Cement silo cement silo dust collector pulse cleaning dust collector pulse cleaning work produced by the induced draft fan in the filter and external pressure, so that the outside of the particulate filter dust gang, led by the fan clean air containing dust into the gas by one or two air inlet is provided using the pulse cleaning cartridge type dust blowing system, the control device and the role of pulse electromagnetic valve. Intermittent injection for the filter to continuously remove dust attached to the filter surface. Cement silo dust collector pulse cleaning using temperature depends on two factors, the first is the maximum temperature of the filter, and the second is the gas temperature must be above the dew point temperature. Currently, due to the large selection of glass fiber filter, the maximum temperature up to 280 ℃, gas above this temperature must take measures to cool, lower than the dew point temperature of the gas must take measures to raise the temperature. For baghouse, the use of temperature and dust removal efficiency relationship is not obvious, it is different from the electrostatic precipitator, dust the top of the warehouse, the temperature changes will affect the dust collection efficiency than the resistance of other effects. Cement silo pulse cleaning dust collector features: The compartment stop the wind pulse cleaning technology to overcome the shortcomings of conventional pulse warehouse roof and sub-room cleaning dust precipitator, strong cleaning ability, high collection efficiency, emissions low concentration, small leakage rate, low energy consumption, low steel consumption, small footprint, reliable, good economic returns. Cement silo pulse cleaning dust collector is suitable for recycling metallurgy, building materials, cement, machinery, chemicals, power, light industry, dusty gas purification and materials. As a result of the sub-room to stop the wind pulse cleaning, blowing a thorough cleaning can achieve the purpose, so extend the cleaning cycle, reducing the energy consumption of cleaning, compressed air consumption can be greatly reduced. Cement silo pulse cleaning dust collector installation: 1, after the hosts on the bottom of the weld cement silo, use clamps to connect the upper and bottom of the host, it is best to host the upper wire rope clamps tight connection with the cement silo solid, when the feed pressure is too high to prevent collapse will host open. (Note: It is recommended to install a pressure relief valve and level meter, it is best to install alarms, in order to improve safety in production) 2, check all connections are sealed fixed. 3. Check that all filters are properly sealed in a fixed disk.